PERMA-bored pile- Driven cast-in-situ pile

PERMA-bored pile - The uncased driven cast-in-situ pile

The PERMA bored pile is an uncased cast-in-situ pile that is low on noise and vibration-free. It is available in two sizes with shank diameters of 40.0 cm or 60.0 cm and load bearing capacities of up to 600 kN depending on the existing subsoil. The maximum length is 16 m or 8 m.

To install the pile, an auger is sunk into the ground up to the desired depth. The PERMA pile is a non-reinforced concrete pile approved according to EN1536 and DIN 4014 standards.

A through hollow-stem auger sealed with a watertight plug at the bottom is rotated into the ground. The support of the borehole wall ensures the cuttings in the auger. On reaching the desired depth, the concrete is pumped under high pressure while the hollow-stem auger is pulled out at the same time.

The material is thus pulled out of the ground by the auger flights and removed from the auger by auger wipers. After the concreting process is completed, the finished pile can be cut and provided with a connection reinforcement. This manufacturing process does not require the complex process of casing.

PERMA pile	Type 1	Type 2
Pile diameter	40 cm	60 cm
Maximum pile length	16 m	8 m
Load bearing capacity of the pile* (depending on the subsoil and the bond length)	300-500 kN	300-600 kN
Model	Raupengerät	LKW mit Kran
Distance from existing construction (does not apply to jumping corners)	8-10 Pfähle	10-12 Pfähle